![]() How must I modify the flashing script flash_eth.scr to support the u-boot environment with a size of 0x20000 and device offset of 0x800000 and the redundant u-boot environment with a size of also 0x20000 and a device offset of 0x1000000 (8MB alignment)? Do I have to “raw copy” a file for the u-boot environment into the eMMC after the mbr.bin and in front of the 1 partition? Or do I have to generate an image for the u-boot environment with mkenvimage? As the flashing of the configblock. Le U-BOAT U-47 TYPE VII B est un sous marin avec coque en résine destiné à la décoration statique. How must I configure the that the u-boot environment is not placed in the cbootimage apalis-tk1.img? ![]() When one is assuming no compression and subtracts the BCT PM375_Hynix_2GB_H5TC4G63AFR_RDA_924MHz.bct size of 8.192 bytes and my custom u-boot u-boot-dtb-tegra-rc.bin size of 582.506 bytes (the original u-boot-dtb-tegra-apalis-tk1-v2016.11-v2.7b1+gitAUTOINC+22e68cbd1f-r0.bin has a slightly bigger size of 583.062 bytes) the remaining size for the u-boot environment should be 8.342 bytes. The apalis-tk1.img has a total size of 599.040 bytes. I could not find the info about the u-boot environment in the cbootimage config file. Les assemblages nécessitent des tiges filetées M3 avec un peu de colle. But yesterday I managed to obtain this partly built 1/32 U-boot conning tower by Andrea miniatures. Mostly midget subs like the Neger, Seehund, Biber, X-craft, Molch, etc. ![]() In the original image the update.sh script states that the u-boot environment is created into the cbootimage apalis-tk1.img (after the BCT and u-boot which are also contained in apalis-tk1.img) which is then flashed into the boot area partition 1 (“primary eMMC boot sector”) in front of the confgblock.bin. Jai redimensionné ce u-boot 1:72 de type VII C de skav56 à 1:48 (138 cm de log au total ) et lai également rendu creux pour quil puisse être utilisé en RC. Hi all, confession time Next to WW1 and WW2 LSP modeling, I sometimes venture in 1/32 submarine modeling. I would like to move the u-boot environment from its original location into the user area partition right after the partition table and in front of the first partition.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |